MCU Protocol error

[igor7205]

What happened

This is frequently caused by running an older version of the
firmware on the MCU(s). Fix by recompiling and flashing the
firmware.

Your Klipper version is: v0.12.0-396-gb7233d119-dirty
MCU(s) which should be updated:
mcu: Current version v0.12.0-396-gb7233d119
rpi: Current version v0.12.0-396-gb7233d119
btt_lis2dw: Current version v0.12.0-114-ga77d0790
Up-to-date MCU(s):

Once the underlying issue is corrected, use the "RESTART"
command to reload the config and restart the host software.

mcu 'btt_lis2dw': Unable to extract params from: config_lis2dw

What did you expect to happen

If I turn off the config then everything works,

How to reproduce

I also have the config in the overwrite section, somehow the system wants the same clipper version from all mcu

Additional information

No response

[GP3D84]

this has nothing to do with ratos
you need to flash your beacon clone to the latest firmware version.

[igor7205]

This is an adxl connected to usb on the pi, no beacon, has always worked well until today
btt_lis2dw: Current version v0.12.0-114-ga77d0790

This file contains common pin mappings for the bigtreetech lis2dw v1.0

To use this config, the firmware should be compiled for the

RP2040 with "USB"

The micro-controller will be used to control the components on the nozzle.

See docs/Config_Reference.md for a description of parameters.

[mcu btt_lis2dw]
serial: /dev/serial/by-id/usb-Klipper_rp2040_btt_acc-if00