G-code preview

[elfl0rd]

Hi!

I saw in the patchout of the April build that the g-code preview should work. But I can't figure out how to get it to work. I have a Voxelab Aquila X2 (H32) printer, I have updated the firmware (tried UBL (without and with EX-UI) and BLT).

But none of them show a preview either in file selection or when printing (honestly I don't even know where the preview should be displayed).
Any ideas?

[classicrocker883]

unfortunately the Gcode preview doesn't work for HC32

you can view it here in the README
https://github.com/classicrocker883/MRiscoCProUI?tab=readme-ov-file#important-info-regarding-hc32

on a side note, I should probably add that info to the release page. Thanks for bringing it up

[elfl0rd]

Thx, missed it.
Yes, on release page it is better I think.