Streamdeck plugin causes mic to "unmute" in Stream Mix B on Revelator IO 44

[NoxFireX]

I use Stream Mix B as a headphone mute, but on boot with the plugin installed the mic input can be heard in the mix even though the mute button is lit up red and the fader is fully down in universal control. This issue goes away once the plugin is removed.

Firmware and software versions below:

[oddbear]

Do you get the same issue if you reinstall the plugin?
There should not be any commands sent to the Revelator software, if no button is pressed, or any knob is turned.

Only thing I can think if there is a issue where both the software and the plugin connects at the exact same time.

If you start the computer, without Louepdeck autostart. Then start the Universal Control. Is the issue there? Then you start Loupedeck with the plugin, does the issue appear then?

Edit: also resetting the device could fix a lot of issues. I have had issues with both the io24 and io44, where some times a power cycle is enough, other times factory reset from UC is enough, but in worst cases I needed to hardware reset (unplugging the usb, wait a little bit, holding both preset buttons, replugging the usb, wait, release the preset buttons).